How to if the computer does not boot up and the ” beep “
What if the computer does not boot up and the ” beep ” ? One of the things that brings more panic in the minds of those who use the computer is the failure to initiate the same, accompanied by the emission of different sounds. This means, of course. One of the components of the PC has a problem, and to resolve the situation must come to understand what actually is. We see some things that you can do in this circumstance.
1.) You can find a great help identifying the meaning of the beeps emitted power. These come from the motherboard, and differ from a model to model. Check the instruction manual of the card, since the ” beep ” depending on the frequency with which they are issued can mean several things.
2.) If you do not have the book, using a different computer, connected to the internet and visit the website www.bioscentral. com. You will find yourself in front of a screen, the Bios Beep Codes. Scroll down the list until you find your model bios, and click on the corresponding item to display the significance of the various sounds. After you’ve identified the failures of the motherboard or of the equipment we can move on to how to eliminate them.
3.) Problems related to RAM : If you are install two memory cards, you can pull out one at a time in order to figure out which of the two of them does not work well. If you have installed only one, then you have to reciprocate.
4.) Problems related to the Video card : It often happens that you have installed two video cards, one of which is integrated and the other outside, in this case you have to remove the external video card is to connect the monitor to the integrated video card and so you can see which card video is not working. One must not forget that after disconnecting the external video card you may have to enter the appropriate section of the BIOS and connect the onboard video.
5.) The problems related to incorrect BIOS setting: In this case, just go into the BIOS and enter the default settings (Load Optimized Defaults) by pressing F10 and Y. If the PC does not start it can be reset manually. For this, you need a screwdriver. You may have to remove the side cover on the left side, is the cornerstone CLEAR CMOS (which has only two positions at all) and places it on the opposite side. After starting the PC (which will not start), and it puts the lintel to its initial position. It remains only to start the PC at this point should work well.
