Installation Guide ADSL Modem
You are about to install a new modem for ADSL and do not know where to start? Below we illustrate in a simple and practice all the steps to install and configure the ADSL modem so that you can make calls and surf safely.
The procedures change depending on a modem is received from the network operator of ADSL or in the case of a modem purchased privately. The guide includes all the possible resolutions for an easy installation.
1.) First, we need to equip all our telephone jacks of a filter. This will allow us to continue to navigate while on the phone, on the contrary, will drop the line internet resulting occupied. Usually, we find a filter in the box of the modem, otherwise the will buy in any phone shop or computer. We proceed by connecting the modem to the electrical outlet and your phone using the supplied cables.
2.) If we will not be using the line wireless, we have to connect the cable largest, Ethernet, modem to the computer, otherwise it will not be necessary. We turn on the modem, if it was sent from our telecom operator is already configured and just follow the instruction, including entering the account name and password given to us by the operator. If your modem has a disk, let the computer and let go following his instructions to configure the software.
3.) If the ADSL modem is a telephone operator, once installed following the steps above, we light it, expect that all the LEDs are illuminated in a fixed manner, we go to our computer, we proceed from the control panel to configure any new connection the Internet using data from our telephone operator. The wizard is the recommended choice when you are not experts. If there is not a wizard or wizard, you can through the address bar of our browser, type a numeric address, http://192.168.0.1 example, we could give us by your service our telephone operator. Just type in the web page obtained the access data to complete the setup, and you can start surfing the Internet.
If you are unable or the first time you make a mistake, let us not take fright. Each modem has a small hole, at the top or bottom or on one side, with a needle, to press on the inside for about 7 seconds, in this manner will have it reset, and we groped a new configuration from scratch.
